FREE: Seahawks car decal

PLEASE READ THROUGH BEFORE YOU START
Step 1 When you receive your decal, apply pressure evenly on the tranfer tape side with squeegee or plastic card. This will ensure the vinyl decal stays on the transfer tape and does not separate along with the backing paper during installation. Clean application surface throughly (DO NOT use ammonia based cleaner such as Windex). Place decal on desired location and apply masking tape across the top, creating a hinge.

Step 2 Flip decal up and pull backing paper off, exposing addhessive.

Step 3 Bring decal down while still holding the bottom end up; apply firm pressure with credit card and rub graphic area from center out to edges forcing all the air out.

Step 4 Gently remove transfer tape by pulling it straight back, at an angle leaving the graphic on the surface.Rub out any air bubbles If they are being stubborn use a pin and poke a tiny hole. Then squeeze the air bubble out by using your thumb or credit card.

You dont have to use tape to create a hinge, this is just to make sure its straight. You can do it free hand just make sure its where you want it. When it sticks its stuck and cannot be removed without damaging decal.

Let me know if you have any questions :) enjoy!

Sorry it took so long to get back to you, I was out of town and had no phone or internet service