FREE: LiftMaster Garage Door Opener Remote Control

The listing, LiftMaster Garage Door Opener Remote Control has ended.

LiftMaster Garage Door Opener Remote Control.

Starting bid reflects the free shipping. Please don't ask me to lower it. These remotes go for $20 or more each.

How do I program my remote control?

Your remote control can be programmed to activate many devices including: garage door openers (GDO), gate operators, commercial door openers and external wired-in receivers.

To program using the learn button

1.Locate the Learn button. ◦Garage door opener: Located on the same side the antenna hangs from, you may have to remove the light lens. The Learn button may be green, orange, red, purple, or yellow with a small LED next to it.
◦Gate operator or commercial door opener: Located on the control or logic board, with a small LED next to it.
◦MyQ Control Panel: Lift the push bar and locate the learn button.

2.Press and release the learn button. ◦If you have a MyQ Control Panel, press the Learn button twice.
Note: The 8500/8500C has a MyQ Control Panel.

3.Within 30 seconds, press and hold the desired button on the remote control for three seconds. The LED indicator light will turn off or the operator lights will blink indicating programming was completed successfully.
4.Press the remote control again to test out. The operator or opener should activate. If not, repeat steps 2 and 3.

After doing a little research I'm going to say you can use this with various garage door opener brands. But it's hit or miss on whether or not it will work on yours if it's not Liftmaster. You can read more on their site...
http://liftmaster.custhelp.com/app/answers/detail/a_id/143/session/L3RpbWUvMTQyMjMxMTk5My9zaWQvKk9vZjNzZG0%3D

All Listia rules apply...