FREE: Itaste 134 Mini, W/Custom Hard Case

The listing, Itaste 134 Mini, W/Custom Hard Case has ended.

Innokin iTaste 134

The standby current： 150uA maximum
Maximum output voltage： 6.0V (unloaded)
Maximum output current： 5.0A（Built in 7A fuse for protection and stability.）
Maximum output wattage： 12.5W(Watts mode)
Resistance of clearomizer： 1.2 ohm (minimum)
Battery: Fits 18350 or 18500 (IMR high drain without protection, maximum current output is more than 5000mA.) iTaste 134 Mini cannot use 2 stacked batteries and any other types of batteries may damage your iTaste 134 Mini.

MAIN FEATURES

Scale Display Wattage: Scale display wattage improves intuitive control and provides more accurate performance…
Variable Wattage: The rotational wheel adjusts wattage in the following increments: 7.0 , 8.0 , 8.5 , 9.0 , 9.5 , 10.5 , 11.0 , 12.0 , 12.5 .
Use lower wattage for low-resistance (ohms) accessories and higher wattage for high-resistance (ohms) accessories
Battery Level Indicator: The iTaste 134 battery capacity is displayed via green, yellow, and red LED lights. Green = Fully Charged Yellow = Half Discharged Red = Charge Needed
High compatibility 510 connector: Will fit iClear16, and iClear30 dual coil clearomizers, as well as standard 510 accessories
ON/OFF Battery Switch: Quickly clicking the power button three times will enable or disable the battery. Once enabled, holding down the button will activate the device. This safety feature prevents the atomizer from turning on while it's in your pocket or bag and prevents accidental changes to your settings.
10-Seconds Cutoff: If the button is held down for 10 seconds or longer, the iTaste 134 will shut itself off until the button is released and pressed again
Short Circuit Protection
Reverse Battery Protection Circuit
LowVoltageWarning